Last edited by Master-B; 6th October 2012 at 01:46 PM.
I can almost certainly make the 15th if that's good for everyone else?
Will the head have to be skimmed before the new gasket goes on? Must admit I've a lot to learn about HG's.
Is it worth considering a thinner TRD HG to increase the compression ratio for a mild performance boost while you're at it?
http://www.fensport.co.uk/Parts/Mode...tegory_12/3192
Last edited by Jimbo_Jet; 20th August 2012 at 10:10 AM.
Hi
bill hulme is the man for the job did mine over two week-ends, he walks the walk and definitely talks the talk, I will always be he is debt, if you can get him to just come over in a supervisory capacity it will be a piece of cake and you know it will be spot on
kev
he will probably come to you all he needs is his tools does the car not drive at all
kev
Compression 180 on all 4
Thermostat replaced
System refilled & bled
Seemed ok on short test drive
Took it up to Bills a week later to test on a longer run, all seemed normal, but on inspection a pool of coolant appeared at the front end of the car when the back end was jacked up & system pressurised - one of the pipe clips had rusted away to almost nothing, allowing coolant to escape. Removed old clip & replaced with a jubilee clip & all my coolant loss issues disappeared.
Ive chalked up about 500 miles now since, mostly spirited driving, no loss of coolant or any other symptoms
Next time you are under your car... or if you are losing coolant, before assuming the worst check your pipe clips folks!
Last edited by Master-B; 6th October 2012 at 01:46 PM. Reason: updated cause & fix details